Takstar PX-10 1500W x2 Professional Power Amplifier for PA

The Takstar PX-10 gives churches, event companies and touring bands serious, dependable power for passive PA speakers and subwoofers, packed into a standard 2U rack unit.

The PX-10 takes the signal from your mixer and delivers up to 1500W per channel into 4 ohms, or 3000W bridged into 8 ohms. That is enough headroom to push full-range cabinets or a pair of subs at a large service, wedding or outdoor event without straining, so your sound stays clean when the room is packed.

Low distortion under 0.03% and a damping factor of 300 keep vocals clear and bass tight and controlled. A full set of protection circuits, from soft start to thermal cut-out, guards both the amplifier and your speakers, and the two-step speed fan keeps it cool through long sets.

In Kenya, the PX-10 suits worship teams powering main speakers and subs, event and hire companies running weddings, conferences and concerts, and venues building a permanent rack. Its 483mm rack width fits standard flight cases for easy transport between gigs.

Key Features

• 1500W per channel into 4 ohms gives you the headroom to drive large PA cabinets and subwoofers at full events.
• Bridge mode delivers 3000W into 8 ohms, so one amplifier can power a single large subwoofer for deep, powerful bass.
• 1050W per channel into 8 ohms suits standard 8 ohm speakers used in churches and halls.
• Distortion below 0.03% keeps vocals, keyboards and worship music sounding clean and natural.
• A damping factor of 300 gives tight, controlled low end with less boomy bass.
• Soft start, short circuit, limiter, DC fault, AC fuse and thermal protection help safeguard your speakers and the amplifier itself.
• A two-step speed fan keeps the amp cool during long services and all-night events.
• The standard 2U rack size fits neatly into flight cases and equipment racks.
• Binding post outputs give secure speaker connections for both stereo and bridge setups.
• Balanced inputs reduce noise and hum over long cable runs from the mixer.
• Selectable 1.0V or 1.4V input sensitivity lets you match the amp to your mixer's output level.
• A 20Hz to 20kHz frequency response covers the full range from deep bass to crisp highs.

Technical Specifications

Q: Should I run the Takstar PX-10 in stereo or bridge mode?
A: Use stereo mode to power two speakers, giving 1500W each at 4 ohms or 1050W each at 8 ohms. Use bridge mode to send 3000W into a single 8 ohm speaker, which is ideal for one large subwoofer. Always check your speaker's power rating and impedance first.

Q: What power supply does the Takstar PX-10 need?
A: It runs on standard Kenyan mains power, AC 220 to 240V at 50Hz. For outdoor events on a generator, use a stable supply and switch the amp on last and off first to protect your speakers.

Q: Can I get the Takstar PX-10 delivered in Nairobi today?
A: Yes. Same-day delivery is available within Nairobi CBD and major suburbs for orders placed before the daily cut-off. Contact us to confirm stock and lock in your delivery window. We also deliver countrywide across Kenya, with lead times depending on your location.